
VALVES
B1
B1.
12
VALVES SERIES 70
VALVES SERIES 70
VALVES SERIES 70
The Series 70 forms part of Metal Work’s full range of traditional
valves.
They are available in sizes 1/8”, 1/4”, 3/8” and 1/2”, versions 3/2,
5/2, 5/3 and double 3/2, with mechanical, manual, pneumatic and
electric drives.
They can be installed in line, onto a wall, on the cylinder (using a special
bracket) or in series (on a multiple or modular base) to suit all possible
applications.
A range of valves (Series 70 LT) designed using components for specific
low-temperature applications is now available for the most commonly
used types and sizes.
These highly reliable valves comply with the main applicable standards,
including Atex, ISO 13849 and SIL, as stated in the documents and
certificates available online.
COMPONENTS SERIES 70
a VALVE BODY: Aluminium
b CONTROL/END CAP: plastic
c SPOOL: chemically nickel-plated aluminium
d DISTANCE PLATES: plastic
e GASKETS: NBR
f PISTONS: Hostaform
®
g PISTON GASKET: NBR
h FILTER: plastic
i SPRINGS: special steel
j OPERATOR: Brass pipe - Stainless steel core
TECHNICAL DATA
1/8’’ 1/4’’ 3/8” 1/2’’
Thread on the valve ports 1/8” 1/4” 3/8” 1/2”
Operating pressure series 70 versions bar
monostable and bistable differential 2.5 to 10
bistable 1 to 10
asserved vacuum to 10
Operating pressure series 70 LT (low temperature) versions bar
hand operated vacuum to 10 -
pneumatic and solenoid/pneumatic t = -40°C to -10°C 5 to 10 -
t = -10°C to +60°C 3 to 10 -
Minimum pilot pressure bar 2.5
Operating temperature range °C
series 70 versions –10 to +60
series 70 LT (low temperature) versions –40 to +60
Nominal diameter mm 5 7.5 13.3 15
Conductance C Nl/min · bar 121.43 264.26 505.52 971.43
Critical ratio b bar/bar 0.32 0.27 0.32 0.43
Flow rate at 6 bar ∆P 0.5 bar Nl/min 400 750 1560 3200
Flow rate at 6 bar ∆P 1 bar Nl/min 550 1100 2150 4600
Installation
In any position (vertical assembly is not recommended for bistable valves subjected to vibration)
Fluid
Filtered air without lubrication; lubrication, if used, must be continuous.
For series 70 LT (low-temperature) versions, it is recommended to use of perfectly dried air.
Recommended lubricant ISO and UNI FD 22
For series 70 LT (low-temperature) it is not expected to be used with lubricated air
.
Maximum coil nut torque Nm 1
Compatibility with oils See chapter Z1
i
e
d
c
f
g
j
b
a
h
#TAG_B1_00040